LED-PRO • User’s Guide 55
4. Operation
Using the Setup Menu
If this error message persists and there is no DVI source or display device
connected to LED-PRO, please contact Barco customer service. In Appendix C,
refer to the “Contact Information” section on page 162 for details.
6. If programming is successful, the following message is shown:
Figure 4-30. EDID Programming Successful Message
Press ESC to return to the EDID DVI In Format Menu.
7. Reconnect the DVI cable from your computer to LED-PRO.
8. Reboot the computer in order for the new EDID information to be read, and for the
new preferred resolution to become available.
EDID Prog Done
Connect DVI input
and reboot the PC
<ESC> = Continue
To Next Page
Loading...
