Chapter 5: Discovering the NGS-D200 and Accessing the Web UI
NOTE: If setting up encoder for streaming using Multicast mode, make sure that no two enocders have the
same mutlicast address.
This can be achieved by either using Standalone mode and setting a unique mutlicast address on each
encoder. OR,
Using managed mode, and setting up a pool of multicast addresses on Management Server - the
management server will assign unique multicast IPaddress to different encoders
l The keyboard locale: See Keyboard Locale
l Your choice of how the device will operate: encoder or decoder
l If configuring the system as an encoder, you will be prompted to select the source type:
o
Remote Desktop Interaction - optimized for capturing computer desktop screens
o
High Resolution Graphics - optimized for highest image quality
o
Full Motion Video - optimized for high frame rate
o
Custom - create your own custom connection profile
NOTE: Once you have finished with the wizard, you will be taken to the Web UI.
NOTE: You can return to the wizard and change settings again from "Quick Setup" on the left navigation panel on
Web UI
5.4 Accessing the Web UI
The Web UIis used for device configuration and operation.
5.4.1 Procedure
1. Navigate to the IPaddress of the device from a web browser (e.g. 10.1.5.50)
2. At the top of the page, enter the credentials created via the configuration wizard
NOTE: You can change the login credentials if necessary.
For more information, see "Admin Account" on page 58
21 NGS-D200 User Guide
To Next Page
Loading...
Need help?
General
