Chapter 8: Streaming
Chapter 8: Streaming
The Streaming menu is used to define audio/video, multicast, and control port ranges, enable or disable reverse audio, as
well make and break Standalone connections between encoder and decoder.
The following topics are covered in this chapter:
8.1 Streaming Statistics
27
8.2 Streaming Settings
28
8.1 Streaming Statistics
the Streaming Statistics page gives real-time information about the status of a connection. After making a connection, you
can use this page to get detailed information from the perspective of the encoder or decoder.
8.1.1 Connection Information (Encoder)
l Client: Displays the IP address of the currently connected client. For multicast connections, the system will display
the IP address of the first client that connected
l Status: Displays the connection status of the encoder`
l LUT: Displays the name field of the currently matching LUT entry
l Max BW: Displays the configured maximum bandwidth allowed to connected clients
NOTE: Max BW should not normally change unless a currently connected client disconnects and a new
client joins matching a different Authorization Entry. It may also change if you manually change the Max BW
via the user interface (e.g. from a separate SSH or console session).
l Interface:
o
Analog HV: Indicates if the input video is RGB (H sync and V sync detected)
o
Analog SOG: Indicates if the input video is RGB with Sync on Green (SoG) or composite sync
o
DVI: Indicates if the input video is DVI
o
“????”: Indicates that no input video is detected
l Video Bytes: Displays the number of bytes currently consumed by video data
l Audio Bytes: Displays the number of bytes currently consumed by audio data
l Horiz. Freq:Displays the refresh rate of the horizontal video signal from the DVI inputs (Hz)
l Vert. Freq: Displays the refresh rate of the vertical video signal from the DVIiput (Hz)
l Horizontal Lines: Indicates the total number of horizontal lines observed in the connected video signal
l Stereo: Indicates if a stereo video signal is detected
l Frames: Displays the total number of frames processed so far
l Slices: Displays the total number of slices processed so far
l Frame Rate: Indicates the number of frames processed per second
l Slice Rate: Indicates the number of slices processed per second
l Local Video Output: Indicates if the encoder is displaying its encoded video source out via the DVI-DOUT port
l Reverse Audio Bytes: Displays the number of bytes currently consumed by reverse (bidirectional) audio
8.1.2 Streaming Statistics (Decoder)
l Server: Displays the IPaddress of the currently connected encoder server
l Status: Displays the connection status of the decoder
27 NGS-D200 User Guide