Barco NGS-D200 User Manual

Chapter 7: Network Configuration
Chapter 7: Network Configuration
Network Configuration allows you to set the device network settings as well as get real-time network statistics.
The following topics are covered in this chapter:
7.1 Network Statistics 25
7.2 Network Settings 25
7.1 Network Statistics
7.1.1 Interface
The Interface section gives real-time information about the device network interface
7.1.2 Routing
The Routing section gives real-time information about device static routes
7.2 Network Settings
7.2.1 Network Interface (IP Address Configuration)
You may want to reconfigure the default network settings of the device:
l DHCP: Enables DHCP on the device
NOTE: Ensure DHCPis enabled if you wish to use the Device Discovery feature in the 4.x Collaboration
Suite.
l MTU Size: Specifies the maximum transmission unit (MTU) size (in bytes). The default size is 1500.
l IP Address: If not using DHCP, specifies the statics IPaddress of the device
l Netmask: Specifies the interface netmask
NOTE: When you have finished making changes, click "Apply" at the bottom of the page. Click "Save Settings" to
permanently save your changes to the device.
7.2.2 Domain Name Service (DNS)Client
You can specify the DNSserver and the device host name.
7.2.2.1 Notes
l You must have preconfigured your DNS server
l If using the device in Managed mode, DNS must already be configured on the Management Server. See the 4.x
Admin UISetup Guide
25 NGS-D200 User Guide

Barco NGS-D200 Specifications

General

Brand	Barco
Model	NGS-D200
Category	Media Converter
Language	English