Barco UDX Series

R5906112 /09 UDX series142
8.12.2 Setup process 3D projection
How to setup 3D projection?
1. Connect the proper source cables to the projector. For more info, see “Connection possibilities”, page 143.
2. Set up and connect your 3D emitter to the projector. For more info, refer to the user manual of your 3D emitter.
3. Power on the projector completely.
4. Select the correct stitched source Input in the Source menu. See “Displaying multiple sources: Stitched
layouts”, page 83.
5. Select the desired Display format. For more info, see “Choosing the desired Display Setup”, page 144.
6. Depending on the chosen 3D emitter, correct the 3D setup. For more info, see “3D emitter Setup”, page 146.
GUI – Installation