Barco UDX Series

R5906112 /09 UDX series34
2.10 Silicone protection sleeve for the RCU
(optional)
Introduction
Barco offers a silicone form fitting protection sleeve for the Pulse RCU. The silicone material keeps it
comfortably, non slip and soft touch. All buttons and holes remain accessible. The sleeve is quick and easy
installed. For ordering information see Barco website.
How to install
1. Pull off the rubber XLR-lid from the RCU.
Image 2-9
2. Place back side (XLR side) of the RCU into the sleeve and pull the other side of the sleeve over the front side
of the RCU.
Image 2-10
Pulse Remote Control Unit