R5906112 /09 UDX series 163
10.2.2 Projector address
About individual projector address
Before a projector, and only this projector, can be controlled via a remote control, an individual address must
be entered in the projector.
This individual projector address can then be used to control the projector via remote control.
Next to an individual projector address, each projector has also a broadcast address for group control.
How to change
1. In the main menu, select System Settings → Communication → IR Control.
Image 10-13: Communication menu, IR control
The IR control menu is displayed.
Image 10-14: IR control menu
2. Select the current projector address and enter a new address.
3. Select APPLY and click OK to apply the changes.
From now on the projector will only listen to this new address and to its broadcast address.
GUI – System Settings
To Next Page
Loading...
Need help?
General
