Barco UDX Series

R5906112 /09 UDX series 67
45°
45°
45°
45°
45°
45°
Image 4-7: RCU to one of the IR sensors
Using the RCU in combination with a 3D emitter
When using a 3D emitter that radiates IR beams (e. g. the optional 3D emitter that Barco provides), the IR
beams of the 3D emitter may interfere with the IR communication between projector and the RCU.
If such interference occurs, connect the RCU to the projector using the remote cable with XLR connector. It is
also be advised to turn the IR receivers of the projector off to avoid the 3D emitter interference. The IR
receivers can be turned off in the GUI: System Settings” → “Communication” →“IR Control “.
Getting Started