13
To payout 1 coin from the hopper press the LH2 button once, to payout 20 then hold the
button down.
The engineers dump is selected by pressing RH5, this has no effect on the hopper balance
and coins can be replaced back into the hopper.
2.3.4 - Test 2 - Reel Test
This test checks the operation and positioning of the three main 16 position reels.
To select this test, enter the self-test mode as described in 2.3.2 and step through the tests
using the RH1 button until 2 is indicated on the LED seven segment or alphanumeric display.
(Refer to section 2.11 for button definitions).
To start the test, press the RH2 button. When the test is selected the three main reels will
spin and stop at position 1, this position can be checked as the first symbol on the reel band
will be positioned on the payline and the joint in the reel band can be detected. When the
reel is rotated by hand the reel illumination lamp should light to indicate that the interrupter
flags are breaking the light to their corresponding photocell for each reel.
2.3.5 - Test 3 - Lamp test
This test checks the operation of all the lamps in the machine.
To select this test, enter the self-test mode as described in 2.3.2 and step through the tests
using the RH1 button until 3 is indicated on the LED seven segment or alphanumeric display.
To start the test, press the RH2 button. When the test starts each lamp will be individually
switched on and off in sequence and then flash all the lamps unless a short or open circuit
bulb is found. This is indicated by the following:
• The faulty bulb will be highlighted with a flashing lamp either side.
• The faulty bulb will also be identified on the alpha display where fitted.
If the RH2 button is pressed and held, all the lamps will flash simultaneously. (Refer to
section 2.11 for button definitions).
To Next Page
Loading...
