15
2.3.9 - Test 7 - RS232 Test
This test checks the operation of the RS 232 link to the electronic data unit if one is fitted.
To select this test, enter the self-test mode as described in 2.3.2 and step through the tests
using the RH1 button until 7 is indicated on the LED seven segment or alphanumeric display.
To start the test, press the RH2 button. In the test a data signal is sent to the data unit and
the RS 232 link procedures tested. An indication of the result of the test will be given on the
machines alphanumeric display i.e. PASS / FAIL. (Refer to section 2.11 for button
definitions).
2.3.10 - Test 8 - Sound Generator Test
This test checks the operation of the sound generation channels of the machine.
To select this test, enter the self-test mode as described in 2.3.2 and step through the tests
using the RH1 button until 8 is indicated on the LED seven segment or alphanumeric display.
To start the test, press the RH2 button. The test consists of the audio signals from channel 1
followed by the audio signals from channel 2 and then the audio signals from both channels
together. (Refer to section 2.11 for button definitions).
2.3.11 - Test 9 - Top Reel Test
Where a single feature reel is fitted, this test checks the operation and positioning of the reel.
To select this test, enter the self-test mode as described in 2.3.2 and step through the tests
using the RH1 button until 9 is indicated on the alphanumeric display.
To start the test, press the RH2 button. The test will cause the top reel to rotate at high
speed. (Refer to section 2.11 for button definitions).
To Next Page
Loading...
