91
7.2.3 Removal
• At the coin mechanism, disconnect the I.D.C. connector or the 10-way CCtalk
connector as necessary from the machine harness.
• At the rear of the coin mechanism bracket, push the white latch to the rear and lift the
bottom of the mechanism, swing the bottom outwards and slide the top out from the
machine.
7.2.4 Refitting
• Slide the top of the coin mechanism into position in the machine, with the groove on
the mechanism fitting the tongue on the machine.
• Swing the bottom of the mechanism into position so that the white securing latch snaps
into place.
• Connect the coin mechanism I.D.C. connector to the harness connector.
• Close the machine access door(s) as described in the specific Machine Manual.
To Next Page
Loading...
