Operation of the gauging unit
41
Instruction Manual PETRO 3003 VOLUTANK Gauging unit BA 140918
The gauging process will resume when the dialog box is acknowledged.
If the angle values are outside the tolerance (±0.1), the message shown
below will be displayed. In this case the prompt must be cleared by
pressing "OK" to confirm that the gauging process should be started.
If the angle values change and move out of tolerance during the gauging
process, the process will be halted (pause) and the operator notified of
the reason. Press "OK" to continue.
To Next Page
Loading...
Need help?
General
