Three-phase synchronous motors DSC1-045-100
Technical alterations reserved
6. Commissioning and maintenance instructions
For information on commissioning the motors, please request a copy of our commissioning and maintenance
instructions, quotion number 00682,
7. Declaration of Conformity
This chapter contains general information on EC Directives, the CE marking and the Declaration of Conformity,
7.1. What is an EC Directive?
EC Directives stipulate specific requirements, The Directives are compiled by the corresponding organisations
within the EU and transposed by all EU member states into national law to guarantee free trade within the
European Union,
An EC Directive only outlines basic minimum requirements, More detailed requirements are included in
standards to which the Directive makes direct reference,
7.2. What does the CE marking signify?
a) The CE marking symbolises conformity to all the obligations incumbent on manufacturers for the product by
virtue of the Community Directives providing for its affixing,
b) The CE marking affixed to industrial products symbolises the fact that the natural or legal person having
affixed or been responsible for affixing the said marking has verified that the product conforms to all
Community provisions for total harmonisation which apply to it and has been the subject of the appropriate
conformity evaluation procedures,
Council Decision 93/465/EEC, appendix I B, a) + c)
We affix the CE marking to the device and include it in the documentation as soon as we have established that
the product fulfils the requirements outlined in the relevant Directives,
If this Baumüller product is used in your machine as specified, you can assume that the product satisfies the
requirements stipulated in 2006/95/EC,
Correct installation is a decisive factor in ensuring that this product complies with 89/336/EEC (EMC Directive),
Since you are installing the product yourself, you are also responsible for ensuring compliance with
89/336/EEC,
We will provide you with assistance in the form of EMC information, which can be found in the corresponding
technical instructions, Once you have satisfied all the requirements outlined in this documentation and the
technical instructions, you can assume (or "suppose") that the product meets all the requirements stipulated in
the EMC Directive,
Please remember to observe all binding national, local and system-specific regulations as well,
In order for you to operate your machine within the EU, the following must be available:
Mark of conformity (CE symbol)
Declaration(s) of Conformity relating to the relevant Directive(s) for the machine
To Next Page
Loading...
Need help?
General
