Beckhoff EL3773 - Page 146

Commissioning
EL3773146 Version: 2.5
Fig.164: Confirming the activation of the configuration
• Confirm new variable mapping, restart in RUN mode (Fig. Generate variable mapping + Restarting
TwinCAT in RUN mode)
Fig.165: Generating variable mapping
Fig.166: Restarting TwinCAT in RUN mode
• In TwinCAT PLC, under the “Project” menu, select “Rebuild all” to compile the project (Fig.Compile
project)
Fig.167: Compile project
• In TwinCAT PLC: log in with the “F11” button, confirm loading the program (Fig. Confirming program
start), run the program with the “F5” button