Parameterization and commissioning
EL675270 Version: 2.1
Reset command taking the example of the TwinCAT AMS ADS Viewer
Fig.69: Resetting the persistent data for MAC ID and baud rate
6.7.2 Object description and parameterization
6.7.2.1 DeviceNet master - EL6752
EtherCAT XML Device Description
The display matches that of the CoE objects from the EtherCAT XML Device Description. We rec-
ommend downloading the latest XML file from the download area of the Beckhoff website and in-
stalling it according to installation instructions.
Parameterization via the CoE list (CAN over EtherCAT)
The EtherCAT device is parameterized via the CoE-Online tab (double-click on the respective ob-
ject) or via the Process Data tab (allocation of PDOs). Please note the following general CoE notes
[}32] when using/manipulating the CoE parameters:
• Keep a startup list if components have to be replaced
• Differentiation between online/offline dictionary, existence of current XML description
• use “CoE reload” for resetting changes
Introduction
The CoE overview contains objects for different intended applications:
• Objects required for parameterization during commissioning
• Objects for indicating internal settings (may be fixed)
The parameterization and the objects required for normal operation will be presented first of all below. All
further objects that are not needed for the normal application case can be found in the lower section of the
table.
To Next Page
Loading...
