BEKA 2016 All rights reserved!
...a product of BEKA
BAL_2152_EP1_Central grease lubrication pump_0816_EN EDV-Nr. 1090200430
11.1.3.Special equipment
Internal memory:
The below listed values are saved at the control unit BEKA-troniX1. They can be read out or
changed with the diagnosis software BEKA-DiSys:
-
Controlling type
-
Version of control unit
-
Serial number
-
Manufacturing date
-
Operating mode
-
Set parameters (adjusting ranges)
The control unit EP-tronic additionally saves the following values:
-
RTC (Real-Time-Clock) date and time, also adjustable for other time zones
-
Operating hours
-
Running time of the pump
-
Number of intermediate lubrication
-
Number of filling errors
-
Number of excess pressure errors
-
Number of stroke monitoring errors
-
Number of revolution monitoring errors
-
Date and time of last diagnosis
-
Number of total diagnosis
-
List of the last 100 errors with error type, as well as indication of time and date
-
List of the last 100 changes of the adjustment with time and date
For a modification of the above mentioned values is the diagnosis software BEKA-DiSys as well
as a data cable necessary (see description BEKA-DiSys).
11.1.4.Adjustment of the operating mode and the adjustment ranges:
The modes and the adjusting ranges can be changed by means of the diagnostic software
BEKA-DiSys.
All adjusting ranges for the lubrication time can be combined with all cycle time ranges.
Adjusting ranges BEKA-troniX1:
Lubrication times: Cycle times:
1 to 16 min. (16 notches every 1 min.) 0.5 to 8 h (16 notches every 0.5 h)
2 to 32 min. (16 notches every 2 min.) 2 to 32 min. (16 notches every 2 min.)
2 to 32 sec. (16 notches every 2 sec.) 2 to 32 h (16 notches every 2 h)
Revolutions of the pump:
1 to16 revolutions (16 notches every 1 revolution)
10 to 160 revolutions (16 notches every 10 revolutions)
170 to 320 revolutions (16 notches every 10 revolutions)
System analysis
port
24
EN
To Next Page
Loading...
