BEKA 2016 All rights reserved!
...a product of BEKA
BAL_2152_EP1_Central grease lubrication pump_0816_EN EDV-Nr. 1090200430
Lubricant:
The system has been designed for commercially available multi-purpose greases of
NLGI class 2 for operation in summer and winter.
-
Use greases with high-pressure additives (EP greases).
-
Only use greases of the same saponification type.
-
Lubricants containing solid contents must not be used (lubricants like graphite or MoS on
2
request).
-
Observe the vehicle manufacturer’s specifications, when you select the lubricant.
Hazards to environment cause by lubricants:
The lubricants which are recommended by the manufacturer of your vehicle, system or machine
correspond in their composition to the common safety regulations. Mineral oils and greases are
generally hazardous to ground water and their storage, processing and transport requires
special precautions.
Inadmissible methods of operation
Operational security of the plant is only guaranteed if it is operated in accordance with the
operating instructions. The limit values stated in the technical data must not be exceeded under
any circumstances.
Transport and storage of the pump:
The pumps of the series EP are packed commercially, according to the regulations of the
recipient country and to the wish of the customer.
There are no limitations with respect to land, air or sea transport.
Store in a dry place at a temperature of -40° C to +70°C.
Handle with care!
4. Technical data:
Motor EP-1, FKGGM-EP:
Operating voltage: 12 V DC / 24 V DC
Speed: 15 rpm.
Current consumption:
Idle running at +20° C: 0.8 A / 0.4 A
Full load at +20° C: 2.2 A / 1.1 A
Fuse: 5A/ 3A
Motor FKGGM-EP with PSU:
Operating voltage: 24 V DC
Connection voltage: 230 V AC / 50 Hz
115 V AC / 60 Hz
(via installed PSU)
Current consumption: max. 0.2 A (230 V AC)
Speed: 15 U / min.
Duty cycle: 10 % ED (10 min)
Operating temperature: -20° C to +70° C
Attention!
8
EN
To Next Page
Loading...
Need help?
General
