BEKA 2016 All rights reserved!
...a product of BEKA
BAL_2152_EP1_Central grease lubrication pump_0816_EN EDV-Nr. 1090200430
11.3. Function sequence of the control unit EP-T2:
The control unit EP-T2 limits the duration of lubrication.
As the brake light serves as current supply of the central lubrication pump, the pump can only
deliver lubricant, if the driver brakes.
Lubrication starts with each braking. After the adjusted lubrication time is the pump switched off,
even if the brake process takes longer. If braking is finished before the lubrication time is over,
lubrication is interrupted and starts again from the beginning with the next braking.
Short interruptions of the brake process of less than 1 sec. are ignored by the control device.
Braking with short interruptions:
Braking shorter than the lubrication time:
Duration
of braking
Short interruption
of braking
Adjusted
lubrication time
Brake
Pump
Interruption
of braking
Adjusted
lubrication time
Duration of braking
Brake
Pump
Duration
of braking
Adjusted
lubrication time
Interruption of braking
Brake
Pump
30
EN
To Next Page
Loading...
Need help?
General
