Benning PV 1-1+ - Procedure for continuous measurement

Operation
5.4 Protective conductor resistance measurement
5290 / 06/2023 en BENNING PV 1-1+ 29
Procedure forcontinuous measurement
1. Connect the 4mm safety measuring lines to the device [}page25].
2. Only for new safety measuring lines: Please carry out a null balance [}page27].
3. Bring the 4mm safety measuring lines into contact with the measuring points.
4. Press and hold the “R
PE
“key until the “R
PE
LOCK”symbol is displayed.
5. The measured protective conductor resistanceR
PE
is shown continuously on the digital
display.
6. To stop the continuous measurement, press the “R
PE
“key.