31Operation
2. Select Change Password and press to display the Input Current Password
window.
3. Use the arrow keys to enter the old password.
• If the password is correct, the Input New Password window displays.
• If the password is incorrect, the password error message displays, and the Input
Current Password window displays for your retry. You can either try another
password or press to cancel the change.
4. Enter a new password.
5. Re-enter the same password to verify.
Do make a note of your password, and keep the note in a safe place for later recall.
6. You have successfully set a new password. Remember to enter the new password
next time you turn on the projector.
7. Press to save your changes and exit.
Disabling the password function
To do this, first and foremost, you have to access the Advanced OSD menu (see page 37
for details).
1. Go to the System Setup : Advanced > Password menu to display the Password
window.
2. Select Power On Lock and use / to set Off.
3. Enter the current password.
• If the password is correct, the Password window displays that Power On Lock
is Off. You will not be asked to enter the password next time when turning on the
projector.
• If the password is incorrect, the password error message displays, and then the
Input Current Password window displays for your retry. You can either try
another password or press to cancel the change.
4. Press to save your changes and exit.
Though the password function is disabled, you need to keep a note of the old password in case
you ever need to re-activate the password function by entering the old password.
Input Current Password
Back
CH100_EN.book Page 31 Wednesday, March 2, 2016 11:54 AM
To Next Page
Loading...
