BenQ W1300 - Custom User Modes & Resetting Pictures

Operation 37
Setting the User 1/User 2/User 3 mode
There are three user-definable modes if the current available picture modes are not
suitable for your need. You can use one of the picture modes (except the selected User
mode) as a starting point and customize the settings.
1. In the Picture menu, highlight Preset Mode and press / to select User 1,
User 2, or User 3 mode.
2. Press to highlight User Mode Management.
This function is only available when User 1, User 2, or User 3 mode is selected up in the Preset
Mode sub-menu item.
3. Press MODE/ENTER to display the User Mode Management page.
4. Press to highlight Reference Mode and press MODE/ENTER.
5. Press to highlight a picture mode that is closest to your need and press
MODE/ENTER and MENU/EXIT to go back to the User Mode Management
page.
6. Here you can rename the User 1, User 2, or User 3 mode by press to highlight
Rename User Mode and press MODE/ENTER. The Rename User Mode page
displays.
7. Press / / / until your desired character is selected and press
MODE/ENTER.
8. Press MENU/EXIT to go back to the main menu once you are done.
9. Press to select a sub-menu item to be changed and adjust the value with / .
See "Fine-tuning the selected picture mode" on page 36 and "Advanced picture
quality controls" on page 39 for details.
10. When all settings have been done, press MENU/EXIT to save and leave the
settings.
Resetting the picture mode
All of the adjustments you’ve done in the Picture menus can be returned to the factory
preset values with a key press on the highlight of Reset.
To reset the picture mode to the preset factory values:
1. In the Picture menu, highlight Preset Mode and press / to select the picture
mode (including User 1, User 2, or User 3) you want to reset.
2. Press to highlight Reset Picture Settings and press MODE/ENTER. The
confirmation message displays.
3. Press / to highlight Reset and press MODE/ENTER. The picture mode will
return to the factory preset settings.
4. Repeat steps 1-3 if you want to reset other picture modes.
Do not to be confused with the Reset Picture Settings function here with the Reset All Settings
in the System Setup : Advanced menu. The Reset All Settings function returns most of the
settings to the factory preset values system wide. See "Reset All Settings" on page 56 for details.
BenQ W1300.book Page 37 Thursday, August 29, 2013 2:07 PM