Operation 55
4. System Setup: Basic menu
Menu
Settings
Menu Display Time
Sets the length of time the OSD will remain active after your last key
press. The range is from 5 to 30 seconds in 5-second increments.
Menu Position
Sets the On-Screen Display (OSD) menu position.
Blank Reminder Message
Selecting On allows the projector to show you to blank reminder
message.
Input Source
Select an input source to be projected.
See "Switching input signal" on page 35 for details.
Source
Rename
Rename the source to your desired name.
See "Switching input signal" on page 35 for details.
Auto Source
Search
Set whether the projector searches automatically for input sources. If
the sources scan is On, the projector will scan for input sources until
it acquires a signal. If the funciton is not activated, the projector
selects the last used input source.
5. System Setup: Advanced menu
Lamp
Settings
Reset Lamp Timer
See "Resetting the lamp timer" on page 63 for details.
Equivalent Lamp Hour
See "Getting to know the lamp hour" on page 59 for details on
how the total lamp hour is calculated.
HDMI
Settings
HDMI Format
Selects an input source type for the HDMI signal. You can also
manually select the source type. The different source types carry
different standards for the brightness level.
HDMI Format is only available when the HDMI signal is selected.
CEC
Enables or disables the CEC function. When you connect an HDMI
CECcompatible device to your projector with an HDMI cable, turnig
on the HDMI CEC compatible device automatically turns on the
projector, while turnig off the projector automatically turns off the
HDMI CEC compatible device.
Baud Rate
Selects a baud rate that is identical with your computer’s so that you
can connect the projector using a suitable RS-232 cable and update
or download the projector’s firmware. This function is intended for
qualified service personnel.
Te s t P a t t e r n
Selecting On enables the function and the projector displays the grid
test pattern. It helps you adjust the image size and focus and check
that the projected image is free from distortion.
FUNCTION DESCRIPTION
BenQ W1300.book Page 55 Thursday, August 29, 2013 2:07 PM
To Next Page
Loading...
