Maintenance 63
Resetting the lamp timer
11. After the startup logo, open the On-Screen Display (OSD) menu. Go to the System
Setup: Advanced > Lamp Settings menu. Press MODE/ENTER. The Lamp
Settings page displays. Press to highlight Reset lamp timer and press MODE/
ENTER. A warning message displays asking if you want to reset the lamp timer.
Highlight Reset and press MODE/ENTER. The lamp time will be reset to '0'.
Do not reset if the lamp is not new or replaced as this could cause damage.
BenQ W1300.book Page 63 Thursday, August 29, 2013 2:07 PM
To Next Page
Loading...
