Operation42
Saturation is the amount of that color in a video picture. Lower settings produce less saturated
colors; a setting of “0” removes that color from the image entirely. If the saturation is too high,
that color will be overpowering and unrealistic.
Setting Film Mode
Highlight Film Mode in the Display menu and select On by pressing / on the
projector or remote control.
This feature helps improve picture quality when projecting composite or S-video image
from a filmsourced DVD or Blu-ray Disc.
Setting 3D Comb Filter
Highlight 3D Comb Filter in the Display menu and select On by pressing / on the
projector or remote control.
This feature separates composite signal to Y (brightness) signal and C (color) signal, and
can help produce clearer and sharper images with correct colors in place.
This function is only available when a composite or S-video signal is selected.
Adjusting the sound
The sound adjustments made as below will have an effect on the projector speakers. Be
sure you have made a correct connection to the projector audio input. See
"Connection"
on page 22
for how the audio input is connected.
Muting the sound
To temporarily turn off the sound,
• Using the remote control
Press MUTE to temporarily turn off the sound. While the sound is off, the screen will
display in the upper right corner of the screen.
To restore the sound, press MUTE again.
•Using the OSD menu
1. Press MENU/EXIT and then press / until the System Setup: Advanced
menu is highlighted.
2. Press to highlight Audio Settings and press ENTER. The Audio Settings
page displays.
3. Highlight Mute and press / to select On.
4. To restore the sound, repeat steps 1-3 and press / to select Off.
Adjusting the sound level
To adjust the sound level,
• Using the remote control
Press or to select a desired sound level.
•Using the OSD menu
1. Repeat steps 1-2 above.
2. Press to highlight Vo lume and press / to select a desired sound level.
BenQ W1300.book Page 42 Thursday, August 29, 2013 2:07 PM
To Next Page
