Instruction Manual
4343
5.7 ACCESS VIA MAGNET APP
The meter can be operated and configured via the Mag-Net mobile app, the connection is performed via
Bluetooth communication channel.
Mag-Net functions:
List available devices and connection list
Instantaneous measures and datalogger access device
Device configuration and access diagnostic information
Firmware update
Mag-Net is available for free for Android and iOS devices
System requirements:
iOS: iOS or iPadOS 10.0 or higher
Android: 8 or higher
Install and start the Mag-Net app
A list of all available devices is shown, by default devices are identified through device S/N: Y7K00000
Select the device you want to connect
Enter the device password, default password is 000000
The first time you connect a message advising the change of the password is displayed, it is strongly
recommended to change the default password the first time you connect, Mag-Net can save the device
password so you do not need to remember it, you can also share the password with others through
the app itself.
Once connected you will see the meter dashboard with instantaneous live measurement and main
information about the device. You can navigate through following sections:
Instantaneous flow rate measure
Meter log
Configuration
To Next Page
Loading...