Sewing preparation
27
2020-02 EN 5020077.20A.04
Adjusting the presser foot pressure
The presser foot pressure is designed to adjust the pressure of the presser foot optimally to the fabric
thickness. When working with thick fabrics, it is recommended to reduce the presser foot pressure. This
provides the advantage that the presser foot is slightly lifted so that the fabric can be moved more easily.
When working with thin fabrics, it is recommended to increase the presser foot pressure. This provides
the advantage that the fabric cannot be moved too easily under the presser foot.
> Touch the icon «Presser foot pressure».
> Move the slide with the touchscreen pen/finger to adjust the presser foot pressure.
2.8 Needle and stitch plate
Changing the needle
> Raise the needle.
> Raise the presser foot.
> Switch off the machine and disconnect it from the power supply.
> Remove the presser foot.
> Loosen the needle clamp screw (1) with the screwdriver.
> Pull out needle downwards.
> Hold the needle with the flat side (2) to the back.
> Push the needle up to the stop (3).
> Tighten the needle clamp screw using the screwdriver.
To Next Page
Loading...
