Appendix
92
2020-02 EN 5020077.20A.04
11.3 Error messages
Message on the display Cause Repair
This stitch number does not exist. > Check the entry and enter the new number.
Stitch pattern selection not
possible in combi mode.
> Check the entry and enter the new number.
The stitch number cannot be
selected in combi mode.
> Select other stitches.
The selected needle and stitch
plate cannot be used in
combination.
> Check whether the correct needle and stitch plate are
attached.
> Exchange the needle and select it in the user interface.
> Exchange the stitch plate and select it in the user
interface.
The winding unit is activated. > Deactivate the winding unit.
The thread indicator is
deactivated.
> To activate both thread indicators, touch the icon
«
Confirm».
> To keep the thread indicators deactivated, touch the
icon «
Cancel».
The main motor isn't running. > Turn the handwheel clockwise until the needle is at its
top position.
> Remove the stitch plate.
> Remove the thread remnants.
> Clean the hook.
> Remove the hook and make sure that no broken needle
tips stick to the magnetic back of the hook.
To Next Page
Loading...
