Bernette b77 - Threading the Bobbin Thread

Sewing preparation
36
2020-02 EN 5020077.20A.04
> Push the bobbin to the right.
– The button «Start/Stop» flashes and the display for winding appears.
> Hold the end of the thread with one hand.
> To start the winding process for a few rotations and then stop, push the button «Start/Stop», so that the
thread is held tight on the bobbin.
> Cut off the thread end next to the inner hole.
> To continue the winding process, push the button «Start/Stop».
> To stop the winding process, push the button «Start/Stop».
> Remove the bobbin and cut the thread.
Threading the bobbin thread
Prerequisite:
• The needle is raised.
• The presser foot is raised.
• The machine is switched off.
> Open the bobbin cover by pushing the release button to the right.