Appendix
88
2020-02 EN 5020077.20A.04
Oiling the needle bar
The needle bar may not move smoothly without lubrication. If the machine is used frequently, the needle bar
should be oiled every 6 months to prevent blocking.
WARNING
Electronically driven components
Risk of injury near the needle bar.
> Switch off the machine and disconnect it from the power supply.
> Remove the protective cap (1) and the screw (2).
> Remove headframe cover (3).
– After removing the headframe cover, pay attention to the moving parts.
> Apply a drop of oil to the movement mechanism of the needle bar, including the connecting rod/needle
bar, needle bar holder and needle bar holder (apply oil to the points marked with an arrow).
> Remove the presser foot.
> Turn the handwheel a few times and remove excess oil with a cloth.
> Attach the headframe cover again.
To Next Page
Loading...
