Bernette b77 - Winding the Bobbin Thread

Sewing preparation
35
2020-02 EN 5020077.20A.04
Winding the bobbin thread
1
2
4
3
1 Spool disc 3 Thread pretension
2 Thread guide 4 Spool pin
> Place the thread spool and the appropriate spool disc on the spool holder.
> For smaller thread spools, use the small thread disc.
> To prevent tangling or tearing of the thread, use the spool net.
> Feed the thread through the thread guide.
> Wind the thread clockwise around the thread pre-tensions.
> Pull the thread end through one of the inner holes of the bobbin and place the empty bobbin on the
bobbin unit.