Bernette b77 - 9 Buttonholes; 9.1 Overview Buttonholes

Buttonholes
79
2020-02 EN 5020077.20A.04
9.3 Sewing a buttonhole automatically
> Attach the Buttonhole foot with slide (RJ).
> Pull out the button holder plate and insert the button.
> Guide the thread through the hole in the presser foot and then place it under the foot.
> Touch the icon «Buttonholes».
> Select the buttonhole stitch.
> Adjust the stitch width and stitch length to the desired width and density.
> Position the fabric under the presser foot so that the marking of the centerline is aligned with the starting
point (1).
1
> Press the button «Start/Stop».
– While the buttonhole lever is raised, the display shows an error message to lower the buttonhole
lever.
> Pull the buttonhole lever down as far as possible until it clicks into place.
> Hold the upper thread vertically to the Buttonhole foot with slide and start sewing.
– After the buttonhole has been sewn, the machine automatically sews a securing stitch before
stopping.