13Operating Instructions
Collapsible Vertical Spool Pin
• found on the back of the sewing computer
behind the handwheel
• essential aid for sewing with more than one
thread, i.e. double needle work
• raise the pin until it clicks into its vertical
position
• add the foam pad A for stability, this
prevents the thread from getting caught on
the spool pin
Supplementary Spool Pin
A
Removing the Needle
• raise the needle
• turn power switch to «0» (off)
• lower the presser foot
• loosen the needle clamp screw
• pull the needle down to remove
Inserting the Needle
• flat side of needle to the back
• insert the needle as far as it will go
• tighten the needle clamp screw
Changing the Needle
!
Refer to the
safety instructions!
To Next Page
