Bernina 1300MDC - Page 66

66 Buttonholes - Important Informaiton
Hooking the Cord onto Presser Foot
No. 3
• insert the needle at the beginning of the
buttonhole
• raise the presser foot
• hook the cord over the center pin on the
front of the foot
• place both ends of the cord in the
grooves on the sole of the foot and pull
them to the back
• lower the presser foot
Sewing
• sew the buttonhole in the usual manner,
do not hold the cord tightly
• the buttonhole will form over the cord,
covering it
Hooking the Cord in the Automatic
Buttonhole Foot with Slide No. 3A
• insert the needle at the beginning of the
buttonhole
• raise the presser foot
• guide the cord under the foot to the right
• hook the cord over the pin at the back of
the foot
• bring the cords to the front of the foot
• pull them into the slit
Sewing
• sew the buttonhole in the usual manner,
do not hold the cord tightly
• the buttonhole will form over the cord,
covering it
031196.50.04_0507_a630_EN