EasyManuals Logo

Beta ALP 4.0 User Manual

Beta ALP 4.0
81 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #34 background imageLoading...
Page #34 background image
2
OPERA
TION
113
GB
RUNNING-IN
The running-in period lasts approximately
10 hours, during which it is advisable to:
Warm up the engine well before starting
off.
Avoid riding at constant speed (chang-
ing the speed allows the different com-
ponents to bed in uniformly and in a
shorter time).
Avoid turning the throttle twist grip more
than 3/4 of its travel.
WARNING:
After the first 1000 km renew the engine
oil.
IMPORTANT:
It is necessary to make sure that after run-
ning for 1000 Km., the metallic filter, posi-
tioned on the final part of the oil tank, is
clean (see page 120). If it should not be
clean, use compressed air to clean it.
Always use high-octane unleaded petrol.
After using the vehicle on rough ground
for the first time, carefully check the
tightening of all nuts and bolts.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Beta ALP 4.0 and is the answer not in the manual?

Beta ALP 4.0 Specifications

General IconGeneral
Displacement349 cc
Final DriveChain
Rear SuspensionMonoshock
Front BrakeSingle disc, 260 mm
Rear BrakeSingle disc, 220 mm
Front Tire90/90-21
EngineSingle cylinder, 4-stroke

Related product manuals