Beta ALP 4.0 User Manual

1
GENERAL INFORMA
TION
108
GB
ELECTRICAL DEVICES
Remove the saddle by sliding it backwards after turning the fixing screw 1/4 of a
turn anticlockwise.
WARNING
To avoid damage to the electrical equipment, never disconnect the cables while the
engine is running.
STAND RELAY A
FUSE B - two 20A
WARNING
Before you replace the blown fuse, trace
and eliminate the failure that caused the
blowing. Never replace a fuse with a
different material (e.g. a length of wire).
Check the fuse in case of starting and
lighting problems.
FLASHER UNIT C
ELECTRONIC CONTROL UNIT D
STARTING RELAY E
VOLTAGE REGULATOR F
A
B
E
C
G
H
F
D

Beta ALP 4.0 Specifications

General

Displacement	349 cc
Final Drive	Chain
Rear Suspension	Monoshock
Front Brake	Single disc, 260 mm
Rear Brake	Single disc, 220 mm
Front Tire	90/90-21
Engine	Single cylinder, 4-stroke