Beta ALP 4.0 User Manual

3
CHECKS AND MAINTENANCE
131
GB
FRONT BRAKE
Check
To check the wear of the front brake, visu-
ally inspect the brake pad ends by look-
ing at the brake caliper from the front. The
brake linings should be at least 2 mm thick.
If the linings are thinner, replace the pads
immediately.
Note:
Carry out the control procedure respect-
ing time intervals and mileage indicated
on the chart on page 141.
REAR BRAKE
Check
To check the wear of the rear brake, visu-
ally inspect the brake pad ends by look-
ing at the brake caliper from above. The
brake linings should be at least 2 mm thick.
If the linings are thinner, replace the pads
immediately.
Note:
Carry out the control procedure respect-
ing time intervals and mileage indicated
on the chart on page 141.
ALP
MOTARD

Beta ALP 4.0 Specifications

General

Displacement	349 cc
Final Drive	Chain
Rear Suspension	Monoshock
Front Brake	Single disc, 260 mm
Rear Brake	Single disc, 220 mm
Front Tire	90/90-21
Engine	Single cylinder, 4-stroke