BIFFI IMVS2000v2 - Section 10: INSTALLATION - START-UP

Installation, Operation and Maintenance Manual
September 2019
MAN720_IMVS2000v2_IOM Rev. 6
Section 10: Installation – Start-Up
Installation – Start-Up
Section 10: INSTALLATION – START-UP
If ordered as part of an actuator, the factory mounts the IMVS2000v2 device on the actuator, makes
pneumatic connections to the actuator, sets up and calibrates the instrument.
If IMVS2000v2 device is purchased separately, you will need a mounting kit to mount the device
on the actuator. See the following instructions (also attached to the mounting kit) for detailed
information on mounting the IMVS2000v2 device to a specific actuator model.
WARNING
The IMVS2000v2 is not provided with specific means for lifting and transporting. Manually move the
IMVS2000v2 according to the effective rules of health and safety of the installation country.
WARNING
It is assumed that the installation, the setting, the commissioning, the maintenance and repair works
are carried out by qualified personnel and checked by responsible Specialists.
WARNING
The end user shall provide circuit-breakers and fuses in the marshalling cabinet of the control room,
to switch off the Mains and any other voltage applied to the IMVS2000v2 cabinet. Before opening the
door of the IMVS2000v2 cabinet it is mandatory to check that any voltage (Mains or Control Voltages)
is off. Breakers, fuses, differential breakers, in general any disconnecting device:
• Shall be in accordance with the local national standards and plant rules.
• Shall be sized to be in accordance to the maximum power accepted by the IMVS2000v2 interface.
• Shall be suitable located and easily reached.
• Shall be marked as the disconnecting device for the equipment.
• Shall not interrupt the protective earth conductor.
WARNING
Avoid personal injury or property damage from sudden release of process pressure or bursting of
parts. Before proceeding with any Installation procedures:
• Always wear protective clothing, gloves, and eyewear to prevent personal injury.
• Personal injury or property damage may result from fire or explosion if natural gas is used
as the supply medium and preventive measures are not taken. Preventive measures may
include: enough ventilation around the unit, re-evaluating the hazardous area classification,
ensuring adequate ventilation, and the removal of any ignition sources.
• Check with your process or safety engineer for any additional measures that must be taken
to protect against process media.
Important
The installation must be carried out in accordance to the applicable standards IEC/EN 60079-14 and
IEC/EN 60079-17 regarding the electrical installations in Hazardous Areas (other than mines) classified
as Zones 1, 2 (gas) and Zones 21, 22 (dust) following IEC/EN 60079-10-1 and IEC/EN 60079-10-2 and
any other applicable national standards and rules.
87