ADVANCED USE MANUAL DD700
Digital cells (if applicable)
Single coil (op code=01, 05, 15)
Run MPP weighing operation
End MPP weighing operation
Discrete input (op code=02)
The whole variables can be programmed using configuration parameters such as big/little endian
The Long variables can be programmed using configuration parameters such as big/little endian
The float variables can be programmed using configuration parameters such as big/little endian and
with exchanged registers
It is not possible to run partial reading or writing operations on multi register variables, for ex. float.
Command-type coils run the described operation in both writing and reading; in the latter case, a
value is returned that indicates the return condition of its execution ( 1=TRUE, 0=FALSE)
To Next Page
Loading...