ADVANCED USE MANUAL DD700
Justification
This can be Right or Left
Press to confirm the set attributes and switch to entering the
coordinates (X,Y) that define the position of the data description on the
printout.
Enter coordinate X, then confirm with .
Enter coordinate Y, then confirm with
.
Press ESC to go back to the customisation functions without entering any
description.
The DEL key is used to delete the number of the entered data.
Enter data value
To enter the value of the general data
press and proceed as explained above.
Enter text
By pressing it is possible to enter a text to associate to the data with a
maximum length of 20 characters. To enter the text, refer to the Using the terminal
chapter in the user manual.
Confirm text entry with , then the printing attributes and coordinates
(X,Y) as explained previously.
Press ESC to go back to customisation functions without entering any text.
The DEL key is used to delete the entered text.
Barcode
Press to display the list of barcodes that can be selected:
Net
Generic Product + Net (code 128)
Generic Code + Net (code 128)
Product Code + Net (indicod ean13)
Product Code + Number of pieces (code 128) (only for operation in CPE
mode)(**)
Number of pieces + Net (code 128)(**)
Product Number of pieces (indicod
ean13) (only for operation in CPE mode)(**)
Number of pieces + Net (indicod ean13) (only for operation in CPE mode)(**)
To enter a barcode, proceed as follows:
press the key for the number that identifies the required barcode (for example,
press
to select
1 Net
);
To Next Page
Loading...