EasyManuals Logo

bintec elmeg be.IP swift User Manual

bintec elmeg be.IP swift
89 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #88 background imageLoading...
Page #88 background image
Safety instructions 88
Safety instructions
Important
Please read the safety instructions carefully before using this router.
Warning
Electrical voltage on power supply, telephone and network
cables is dangerous! Failure to observe the safety instructions can
lead to dangerous situations, which can also result in severe injury or
death.
To prevent personal injury and damage to property as well as danger
to domestic animals and livestock, the following must be observed
when installing and operating the be.IP swift:
The router must not be opened.
Do not install the router or connect or disconnect any lines
during a thunderstorm.
Operation is only intended for dry rooms inside buildings.
Choose a place for installation that is as far as possible out
of the reach of domestic animals and livestock.
The mains socket must be located close to the router and be
easily accessible.
Lay the cables so that no one can step on or trip over them.
Connect cables only to the designated sockets, use only
approved accessories.
Do not allow liquids to infiltrate the interior of the router (risk
of electric shock or short circuit).
Avoid direct sunlight. Ensure sufficient ventilation.
Avoid operating in the direct vicinity of a radiator.
Before drilling, make sure that there is no domestic
installation at the drilling site. Damage to gas, power, signal,
or water lines may result in danger to life or property.
Ventilation slots are required for cooling and must not be
covered.
The unit may only be operated with the enclosed plug-in
power supply unit.

Table of Contents

Other manuals for bintec elmeg be.IP swift

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the bintec elmeg be.IP swift and is the answer not in the manual?

bintec elmeg be.IP swift Specifications

General IconGeneral
Brandbintec elmeg
Modelbe.IP swift
CategoryNetwork Router
LanguageEnglish

Related product manuals