V 1.31
2021. 05 83 / 171 Doc. # : BN-OP-C7
Upon completion of BMS Server IP setup, the Ping Test can be conducted to check
successful network connection. If choosing ‘Ping’ button, “Ping: 100% Succeeded”
message will be shown for a successful connection, whereas “Ping: Failed” message will
be shown for connection failure.
- Wired usage is recommended for a BMS Server-installed PC network.
- When setting BMS Server, directly enter the IP of the BMS Server-installed PC by
selecting "Manually" if searching with DHCP has failed.
To Next Page
Loading...
