17
(2) Precautions for Use
① Precautions for Equipment
ⅰ. Avoid the damp locations, and do not operate the equipment
with wet hands.
ⅱ. Use BPM-1200(1010) under conditions of 10℃∼45℃ of
circumstantial temperature and 30％∼85％ humidity.
ⅲ. Do not use the locations where moisture level could go up
considerably or where air is not ventilated properly.
ⅳ. Do not use the locations close to electrical heating apparatuses.
ⅴ. Do not use the locations where exposed to direct sunlight.
ⅵ. Do not use the locations where sudden impact or vibration
could be received.
ⅶ. Do not use the locations exposed to chemical or explosive gas.
ⅷ. Make sure to prevent dust and especially metal debris, from
penetrating in.
② Precautions for Electric Safety.
ⅰ. To prevent electric noise during use, the product should be
installed apart from dynamo, X-ray equipment, broadcast
equipment or portable cables. An inaccurate result may occur
when these equipment are placed near the product.
ⅱ. Check the appropriate power supply of the product is suitable.
ⅲ. Check all connecting part is properly connected.
ⅳ. If The product is not completely grounded, the noise may occur.
③ Precautions for Use
ⅰ. Do not disassemble or Dismantle the product.
ⅱ. Completely unfinished product installation Do not connect the
power from the state.
To Next Page
Loading...
