Biotage
®
ELSD-A120 User Manual 41
Optimizing Performance
5
Location of the Detector
Location of the Detector
Place the detector conveniently near your Isolera system. The
modular design of ELSD-A120 enables you to locate it anywhere
within the limitations imposed by the length of the power cord, fluid
lines and signal cables.
Only connect the detector to the Isolera system using the ELSD-A120
Assembly Kit (P/N 414126
) supplied with the detector.
Provide approximately four inches (10 cm) of space behind the
detector so that the cooling fan intake is not impeded, and to allow
easy access to the rear panel.
ELSD-A120 can be placed within 2 meters of an extraction unit, using
the exhaust tube provided.
To Next Page
Loading...
