birddog P240 - System Menu Functions

22
System Menu
Pelco ID
When using RS485 (PELCO P/D) control, set Camera ID to the controlled address. This value is from 001-255.
IR-Receive (Infrared Signal Reception)
When this is set to OFF, the camera does not receive the signal from the infrared remote controller. Be sure to keep
it set to ON when you use the infrared remote controller. Note that you cannot set IR-RECEIVE to OFF when you
operate the menu using the infrared remote controller. To set it to OFF, use the appropriate VISCA controller.
Display Info
When this item is set to ON, the camera conguration is displayed for approx. 3 seconds on the screen when the
camera is powered on or rebooted.
Preset Memory
This feature allows you to save the image parameters to PRESET memory. Parameters such as picture, white
balance, exposure, focus mode, zoom positions can be saved with the preset.
Factory Reset
Select this item to set camera back to the factory default setting. Press the HOME button to conrm the action. All
user settings for the camera will be deleted.
Tally Mode
Select ON to enable the camera Tally lights.
Tele Convert Mode
The larger sensor of the P240 provides for two zoom ranges. When set to OFF, a 20x optical zoom is available.
When set to ON, a HD crop of the sensor provides for a 40x optical zoom.
Reload Preset 1
When set to ON, preset 1 is set to the Home position. The camera moves to the Home position when it is powered
on or reset.
Auto Focus
Set the speed of auto-focusing from Low to Normal.
Video Format
Select VIDEO FORMAT, press the “←” button to choose the video format, then press “→” (Pressing “→” button
changes the value on some product models) or HOME button to conrm. After conrmation, press the HOME
button again to restore it. The camera will reboot by itself and the new video format is activated.
• You can cancel it by pressing the MENU button.
• Depending on the video client software you are using, some video software may need to be restarted
to obtain the new video format.
The camera video format can also be changed by setting the rotary DIP switch at the back of the unit.
SV (Software Version)
Software Version Number that is currently running on the camera, you may need this information for technical
support.