26
Storing the Camera Settings in Memory Using Presets
Using the preset function, six sets of camera shooting conditions can be stored and recalled. The six sets of
camera shooting conditions can be stored and recalled by using remote controller. Up to 128 presets via protocol
programming.
This function allows you to achieve the desired status instantly, even without adjusting the following items each
time.
• Pan/Tilt Position
• Zoom Position
• Focus Auto/Manual
• Focus Position
• AE Mode
• Shutter control parameters
• Bright Control
• Iris control parameters
• Gain control parameters
The settings stored using this function are recalled when the power is turned on.
1. Press the RESET button to reset the pan/tilt position.
2. Adjust the position, zooming, focusing and backlighting of the camera.
3. While holding down the PRESET button, press any of the POSITION buttons, 1 to 6, in which you want to store
the settings.
Recalling the stored settings
Press any of the POSITION buttons, 1 to 6, in
which you have stored the settings.
Cancelling the preset memory
While holding down the RESET button, press the
POSITION button from which you want to cancel
the settings.
NOTE:
• When the power is turned on, the camera starts with the settings stored in POSITION 1, so if you want
to retain the previous pan and tilt positions, store those positions in POSITION 1.
• While storing or cancelling the settings in one POSITION, you cannot call up, store or cancel the
settings in another POSITION.
• When the menu is displayed on the screen, you cannot store, recall, or cancel a setting. Return to the
normal display before starting these operations.
• Exposure Compensation On/O
• Exposure Level
• Backlight Compensation On/O
• White Balance Mode
• R/B Gain
• Aperture Control
• WD Parameter
CAMERA SELECT
STD
PRESET RESET
REV
Press a POSITION button
While holding down PRESET Button
To Next Page
Loading...
