birddog P240 - Image Detail Settings; Detail Menu Controls

40
Speed (white balance speed)
You can adjust the speed at which the camera reaches the white convergence point when AUTO is chosen. Choose
a value from 1 - 5, from slow to fast.
Oset
The white convergence point can be shifted when WHITE BALANCE mode is AUTO or ONE PUSH. The range is
from –7 to 0 to +7. White balance is shifted toward blue when a negative value is chosen, and it is shifted toward
red when a positive value is chosen.
Matrix (Color Matrix)
You can emphasize or weaken a specic color region while keeping the white convergence point unchanged.
When you turn this ON, the following items are displayed for adjustment.
Detail Tab
Mode
Auto: Contour correction signal is automatically added.You can set the volume of the contour correction signal.
Choose a LEVEL value from 0 to 15. The greater the value, the stronger the contour correction signal.
Manual: This setting allows you to manually congure the following settings.
Bandwidth
Set the bandwidth for signals undergoing contour emphasis. You can choose from DEFAULT,
LOW, MIDDLE, HIGH, and WIDE. For example, when you choose MIDDLE, the middle range of the signals is elevated,
and contours in that middle range are emphasized.
Crispening
Choose the neness of the objects subject to contour correction with contour correction signals. Choose a value
from 0 to 7. When you choose a higher value, minute contour correction signal elements are removed, and only the
high level contour correction signals are left,which reduces noise. When you choose a lower value, minute contour
correction signal elements are added to the picture, increasing noise.
H/V Balance
Choose the ratio for horizontal and vertical contour correction signal elements. Choose a value from –2 to 0 to +2.
When you choose a higher value, the horizontal contour correction elements become greater compared to the
vertical elements.
B/W Balance
Adjust the balance between contours in black on the low brightness side of the spectrum and contours in white on
the high brightness side. Choose from TYPE 1 to TYPE 5. The ratio of contours in black is higher for TYPE1 while the
ratio of contours in white is higher for TYPE 5.
Limit
Choose the maximum value for the amount of contour emphasis in black on the low brightness side of the spectrum
and in white on the high brightness side. Choose a value from 0 to 7.