Bizerba SC II Series - 6.6.3 Calling PLUs After Switch-over; 6.6.4 PLU Call-up Without PLU Text; 6.6.5 PLU Call-up With Automatic PLU Prefix

Operation Operating instructions SC II
44 / 107 61429850113 en-US
6.6.3 Calling PLUs after switch-over
(unit price input/PLU input)
Menu setting
- In the <Basic sales settings> configuration, selection 5363 / PLU no.
Basic setting
- Select "Unit price input" in the standard menu.
- Select "Set", "Timeout" or "Enter" from the PLU Confirmation menu.
Switch from unit price input to PLU input.
-
Enter PLU no.
PLU confirmation takes place after:
– Filling of PLU input places [set]
– Expiration of about 0.5 seconds [Timeout]
– the <Enter> key has been pressed.
6.6.4 PLU call-up without PLU text
Direct or indirect PLU call-up.
Direct access via PLU key, e.g. <PLU
1>.
Illustration41: PLU without text
The message "PLU without text" appears
1
.
The article has been defined in the PLU
maintenance without text.
6.6.5 PLU call-up with automatic PLU prefix.
Menu setting
- In the <Basic sales settings> menu configuration, selection 5363 / PLU no.
Basic setting
- In "PLU input positions", enter 3 for example (3-digit PLU no.).
- Select "Set" in "PLU confirmation".
- In "Automatic PLU prefix No." enter the No.
- In the "PLU Prefix" menu in data maintenance, Select 2952:
- "PLU Prefix Number:", enter the "Number sequence" and the "Display value".