107
1. Press Delay to choose Delay which will display in a blue color.
2. Input ‘20’ from the keyboard and choose the unit ‘ns’. The delay is set to 20 ns.
When the frequency, high level, low level, pulse width and delay are set, the waveform
generated is shown in Figure 77.
Example 5: Generate a Noise
Generate a noise waveform with 0.5 V standard deviation and a 1 V mean.
⚫ Set the Stdev.
1. Press Waveforms → Noise → Stdev to choose Stdev which will display in a blue color.
2. Input ‘0.5’ from the keyboard and choose the unit ‘V’. The standard deviation is set to 0.5 V.
⚫ Set the Mean.
1. Press Mean to choose Mean which will display in a blue color.
2. Input ‘1’ from the keyboard and choose the unit ‘1’. The mean is set to 1 V.
When the standard deviation and mean are set, the noise generated is shown in Figure 78.
To Next Page
Loading...
