Blackmagicdesign HyperDeck Extreme 8K HDR User Manual

Getting Started with
HyperDeck Extreme Control
HyperDeck Extreme Control is a remote control panel that lets you control up to 8 HyperDeck
disk recorders or broadcast decks from a single control panel.
All playback and record units are controlled via the RS-422 connections on HyperDeck
Extreme Control’s rear panel.
If you have previously used broadcast decks with a search dial and edit controls, then
HyperDeck Extreme Control will feel very familiar to you. The controls follow a similar layout,
soyou can operate the unit comfortably with confidence. The search dial even has a mechanical
clutch built in giving you a tactile response when using the shuttle or position modes.
This section of the manual will show you how to get started with your HyperDeck Extreme
Control, including plugging in power, connecting HyperDeck Extreme, and making sure the
‘remote’ button is enabled so you can control the unit remotely.
Plugging in Power
To power your HyperDeck Extreme Control, connect an IEC cable to the AC power input on
the rear of the unit. Youcan also use the 12V DC input if you want to connect external power
or redundancy via an external power supply, for example an uninterruptible power supply or
external 12V battery.
67Getting Started with HyperDeck Extreme Control

Blackmagicdesign HyperDeck Extreme 8K HDR Specifications

General

Brand	Blackmagicdesign
Model	HyperDeck Extreme 8K HDR
Category	DVR
Language	English