Blackmagicdesign HyperDeck Extreme 8K HDR - Using the Transport Controls

Using the Transport Controls
You can also use the transport controls on the HyperDeck Extreme Control to navigate to
your in andout points. The two rows of transport controls feature buttons commonly found on
traditional broadcast decks and will be familiar to you. These buttons include ‘preroll’, ‘record’,
‘edit’, ‘eject’, ‘rewind’, ‘play’, ‘fast fwd’ and ‘stop’.
‘Skip’ reverse and ‘skip’ forwards buttons operate like previous and next buttons on file based
decks such as the HyperDeck Studio HD Mini, so you can quickly navigate from clip to clip.
PLAYBACK
RECORD
TRIM PLAYER
REF
SERVO
REMOTE
RECORDER
HOURS MINUTES SECONDS FRAMES
IN
INPUT PREROLL SKIP REC SKIP
SHUTTLE JOG POSITION
EDIT EJECT REW PLAY F FWD STOP
OUT
ENTRY
DELETE
M
M
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1
2
Using REW, PLAY, F FWD and STOP buttons on the front panel let
you quickly control your video on file and tape based decks.
To locate your timecode point, make sure your ‘player’ has reference and is in remote, then on
the controller:
1 Press the ‘recorder’ button to control the deck you have previously selected as your
record deck.
2 Press the REW to F FWD buttons to rewind or fast forward.
3 Once you have reached your timecode, press STOP to stop playback and define select
your in point by pressing the ‘entry’ and ‘in’ buttons together.
The HyperDeck Extreme Control also features other transport controls for file based decks.
Skip forward and skip back
If you are using a file based deck for record or playback, such as HyperDeck Extreme, youcan
use the ‘skip’ forward and reverse buttons. Press ‘skip’ reverse once to skip back to the first
frame of the current clip. Press ‘skip’ forward and you will skip forward to the first frame of the
next clip.
PLAYBACK
RECORD
TRIM PLAYER
REF
SERVO
REMOTE
RECORDER
HOURS MINUTES SECONDS FRAMES
IN
INPUT PREROLL SKIP REC SKIP
SHUTTLE JOG POSITION
EDIT EJECT REW PLAY F FWD STOP
OUT
ENTRY
DELETE
M
M
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1
2
The ‘skip’ buttons are either side of the ‘rec’
button. Pressing ‘skip’ reverse when already
located on the first frame of a clip will navigate
you to the first frame of the previous clip.
Record
To start recording, press the ‘rec’ and ‘play’ buttons at the same time. During recordings you
can switch which storage media your HyperDeck Extreme is recording to by holding down the
record button for three seconds.
76HyperDeck Extreme Control Workflow